FAQ
The HomeServer logic differs in terms of the commands and outputs. The outputs can be used to send the results of the nodes to the KNX or link them directly to other nodes via PINS. Commands are used to trigger alarms, call up light scenes and sequences, etc. Please find attached a pdf document with important information on the basic working principles of the logic. You will also find a full description of the function blocks.
Emails are only sent once a connection to the email provider has been made via the internet. If sending fails, you can use the mail retry parameter to set the time after which the transmission routine will be started again. Please find attached a pdf document with important information on sending emails. You will also find a complete overview of the relevant settings.
The Gira HomeServer is the on-board computer for the smart home. It connects the KNX system’s electrical installation to the computer network and the internet. With its various operating devices, it gives you centralised control over intelligent building technology – at home or on the move. What’s more, it also allows for integration of a large number of further technologies, such as a door communication system, cameras and audio systems.
No, after a factory reset, the password on the device remains activated.
For end-customers, the device password should be in the documentation provided by the electrical engineering firm. If this is not the case, please contact your specialist installer as the device is built-in and therefore you cannot access it.
If you have updated the firmware of the device for which you have not yet received a password, the new password after the firmware update will be “device”.
No, the code can be scanned into the device using a QR code reader.
This QR code contains the MAC address and the factory-set password.
Can’t find what you were looking for?
Please
call us
We're happy to help.
+49 2195 602 6996
Monday to Friday 7.30 AM to 8.00 PM
Saturday from 8.00 AM to 12.00 PM