The holder for rocker buttons and pushbutton switches is different. Therefore, it is not possible to attach a rocker to a pushbutton switch.
The speaker cover and operating buttons can be supplied separately as spare parts for the Gira radio.
Otherwise, the device is considered to be a single unit.
A “reset” returns the controller to its delivery status. To do this, press the + (plus) and - (minus) buttons at the same time for more than 10 seconds. Following this, a display test is automatically carried out. The date and time for initial start-up can be set.
Notes:
Devices with no index label (e.g. RTR top unit with clock, item no. 0389 xx)
In the case of devices with no index label, the rate deviation factor must be noted before performing the reset. You can find this factor on the back of the top unit. Once you have programmed the time and date, set the rate deviation as follows:
Devices with index label (e.g. RTR top unit with clock, item no. 0389 xx) index: I00)
In the case of devices with an index label, the rate deviation correction factor is permanently stored in the EEPROM.
Yes, the cover frame can be installed in your bathroom.
Even if the frame gets a little bit wet after showering, it will dry out.
It is important that it is installed outside of the safety areas.
The room temperature controller with clock does not have a general switch-off function. You can, however, permanently switch it from automatic mode to the lowering temperature (moon symbol).
To do this, press the “-” button for around 5 seconds. The temperature level indicator will then change to the moon symbol (= lowering temperature) and the indicator in front of the clock symbol will go out.
To return the room temperature controller with clock to automatic mode, briefly press the Prog. button.
We're happy to help.
Monday to Friday 7.30 AM to 8.00 PM
Saturday from 8.00 AM to 12.00 PM