FAQ
The room temperature controller with clock does not have a general switch-off function. You can, however, permanently switch it from automatic mode to the lowering temperature (moon symbol).
To do this, press the “-” button for around 5 seconds. The temperature level indicator will then change to the moon symbol (= lowering temperature) and the indicator in front of the clock symbol will go out.
To return the room temperature controller with clock to automatic mode, briefly press the Prog. button.
A “reset” returns the controller to its delivery status. To do this, press the + (plus) and - (minus) buttons at the same time for more than 10 seconds. Following this, a display test is automatically carried out. The date and time for initial start-up can be set.
Notes:
Devices with no index label (e.g. RTR top unit with clock, item no. 0389 xx)
In the case of devices with no index label, the rate deviation factor must be noted before performing the reset. You can find this factor on the back of the top unit. Once you have programmed the time and date, set the rate deviation as follows:
- Press Set and Prog at the same time for approx. 10 seconds. “n” flashes and then the clock appears, target or actual. (Time is factory-set)
- Press the “Plus” button ten times until a flashing “U” appears.
- Press Set to select and set the desired value using the plus or minus button.
Devices with index label (e.g. RTR top unit with clock, item no. 0389 xx) index: I00)
In the case of devices with an index label, the rate deviation correction factor is permanently stored in the EEPROM.
Yes, the cover frame can be installed in your bathroom.
If the frame gets a little bit wet after showering, it will dry out again.
All inserts from the System 2000 and System 3000 are suitable for use in the System 55 and are compatible with the Standard 55, Event, Esprit, E3, E2, Studio, ClassiX, TX_44 and E22 programmes.
The abrasion resistance of our black matt and anthracite devices has been tested.
Test method:
In accordance with DIN EN 60068-2-70 with abrasion equipment from INNOWEP GmbH, 10,000 test cycles: the surface painted in anthracite and black matt passed the abrasion test mentioned.
Can’t find what you were looking for?
Please
call us
We're happy to help.
+49 2195 602 6996
Monday to Friday 7.30 AM to 8.00 PM
Saturday from 8.00 AM to 12.00 PM