Flush-mounted floor empty housing

Flush-mounted floor empty housing

The housing is used to accommodate flush-mounted devices with support ring mounting from the areas of installation and communication technology (e.g. socket outlets, socket outlets with full cover plate, TAE connection boxes etc.). For complete units the

housings can be mounted side by side by means of connecting clamps at the rear. When installed in floors, any water seeping in must be able to drain out via the knockout in the bottom section.

Dimensions

(in mm)

Upper section with hinged cover Die-cast aluminium

W 112 x H 112 x D 61.5 mm

Upper section with hinged cover Matt stainless steel

W 112 x H 112 x T 63.9 mm

Technical data

Protection type

IP 41

Socket outlets

TOP